Dacor Modernist wall oven
showing C-23
C-23 appears when the temperature probe of a Dacor Modernist oven reads as shorted while the oven is running.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and calibration
- Source: Dacor
Book a visit
Three short steps, about a minute.
or call (844) 407-1890
Loading appointment form…
The appointment form couldn’t load. Please try again.
What C-23
actually means.
C-23 appears when the temperature probe of a Dacor Modernist oven reads as shorted while the oven is running.
Dacor oven display
What to do when C-23 shows on the ovenKind of codeTemperature sensor
The reading from the temperature probe fell outside what the control will trust, or climbed far higher than the setting. A loose connector or a probe that has drifted is ruled out before the control itself, and a reading that runs away means the breaker goes off first.
Usually leads toTemperature sensor and calibration
Baking that comes out burnt or pale at the usual setting, traced to the sensor, its wiring or an oven that simply needs calibrating.
Shows up asOven Error Code
The oven shows letters and numbers, beeps, and stops a cycle or refuses to start one.
MakeDacor
A luxury brand owned by Samsung, whose built-in ovens include steam-assisted and combination models.
SourceDacor user manual: Modernist built-in electric wall oven DOB30M977
Dacor Modernist wall ovens with the temperature probe (DOB30M977 manual).
Before you book,
in this order.
Each step comes from Dacor's own guidance for C-23 on its ovens. Follow it to the end: the last card says whether this is a visit.
Press OFF and restart the oven.
If C-23 persists, disconnect power for at least 30 seconds and reconnect.
If it keeps returning, book a visit.
Still there?
It usually turns into temperature sensor and calibration. Book with the code and the model number.
What not to do
C-23 is not the cavity sensor, which reports as C-20. It concerns the probe.
What you may
notice with it.
The oven problem C-23 tends to arrive with. Answer these at the oven before anyone is booked.
All problems
Where C-23 usually leads
Temperature sensor and calibration.
Dacor
ovens.
A luxury brand owned by Samsung, whose built-in ovens include steam-assisted and combination models.
Dacor oven repairMore Dacor codes
Temperature sensor on other makes
Single wall oven
One oven cavity set into a cabinet at chest height, with its own controls above the door and nothing to cook on above it.
Double wall oven
Two full oven cavities stacked in one tall cabinet, sharing one control panel and one power supply but heating on their own.
Steam oven
A built-in oven that adds water vapor to the cavity, alone or with convection heat, fed from a tank or a water line.
In Dacor's own words
Temp probe sensor is short when
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Dacor Modernist wall ovens with the temperature probe (DOB30M977 manual).
Dacor C-23 oven repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about C-23.
Can I clear C-23 myself?
Does C-23 on my Dacor mean the oven is broken?
Should I keep roasting with the probe after C-23 on my Dacor?
Back to your everyday
Still showing C-23?
Book with the code exactly as shown, the full model number, and whether you can smell gas or burning — with a code, that is where the diagnosis starts.