Monogram Advantium speed oven
showing F1
On a Monogram speed oven built on Advantium, F1 means the thermal sensor circuit reads open.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and calibration
- Source: Monogram
Book a visit
Three short steps, about a minute.
or call (844) 407-1890
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F1
actually means.
On a Monogram speed oven built on Advantium, F1 means the thermal sensor circuit reads open. GE lists the same meaning for both its 120V and 240V Advantium platforms.
Monogram oven display
What to do when F1 shows on the ovenKind of codeTemperature sensor
The reading from the temperature probe fell outside what the control will trust, or climbed far higher than the setting. A loose connector or a probe that has drifted is ruled out before the control itself, and a reading that runs away means the breaker goes off first.
Usually leads toTemperature sensor and calibration
Baking that comes out burnt or pale at the usual setting, traced to the sensor, its wiring or an oven that simply needs calibrating.
Shows up asOven Not Heating
The oven turns on and the display counts, but the cavity stays cold or only lukewarm after a long preheat.
MakeMonogram
GE Appliances' luxury line, with wall ovens, steam ovens and speed ovens in professional and minimalist styles.
SourceGE Appliances support: Advantium 240 Volt codes
Monogram Advantium speed ovens: 240V ZSC2200/ZSC2201/ZSC2202 and 120V ZSB9131 (built 2020-2024).
Before you book,
in this order.
Each step comes from Monogram's own guidance for F1 on its ovens. Follow it to the end: the last card says whether this is a visit.
Press Clear/Off or Cancel and program again.
If F1 repeats, disconnect power for a minute or two and retry.
Book a visit if F1 persists.
Still there?
It usually turns into temperature sensor and calibration. Book with the code and the model number.
What not to do
F1 on a Monogram speed oven is not the keypanel code F1 means on GE wall ovens.
What you may
notice with it.
The oven problems F1 tends to arrive with. Answer these at the oven before anyone is booked.
All problems
Where F1 usually leads
Temperature sensor and calibration.
Monogram
ovens.
GE Appliances' luxury line, with wall ovens, steam ovens and speed ovens in professional and minimalist styles.
Monogram oven repairMore Monogram codes
Temperature sensor on other makes
Single wall oven
One oven cavity set into a cabinet at chest height, with its own controls above the door and nothing to cook on above it.
Double wall oven
Two full oven cavities stacked in one tall cabinet, sharing one control panel and one power supply but heating on their own.
Speed oven
A compact built-in oven that combines convection heat with microwave energy in one cavity to cook in a fraction of the usual time.
In Monogram's own words
Open Thermal Sensor
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Monogram Advantium speed ovens: 240V ZSC2200/ZSC2201/ZSC2202 and 120V ZSB9131 (built 2020-2024).
Monogram F1 oven repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F1.
Can I clear F1 myself?
Is F1 on my Monogram speed oven the same on 120V and 240V models?
Can I still microwave with F1 on my Monogram?
Back to your everyday
Still showing F1?
Book with the code exactly as shown, the full model number, and whether you can smell gas or burning — with a code, that is where the diagnosis starts.