Kenmore wall oven
showing F4/E1
On a Kenmore 665 wall oven, F4/E1 points at the meat probe: the control reads a short in the probe, its jack or the harness behind the jack.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and calibration
- Source: Kenmore
Book a visit
Three short steps, about a minute.
or call (844) 407-1890
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F4/E1
actually means.
On a Kenmore 665 wall oven, F4/E1 points at the meat probe: the control reads a short in the probe, its jack or the harness behind the jack.
Kenmore oven display · also shown as F4 E1
What to do when F4/E1 shows on the ovenKind of codeTemperature sensor
The reading from the temperature probe fell outside what the control will trust, or climbed far higher than the setting. A loose connector or a probe that has drifted is ruled out before the control itself, and a reading that runs away means the breaker goes off first.
Usually leads toTemperature sensor and calibration
Baking that comes out burnt or pale at the usual setting, traced to the sensor, its wiring or an oven that simply needs calibrating.
Shows up asOven Error Code
The oven shows letters and numbers, beeps, and stops a cycle or refuses to start one.
MakeKenmore
A Sears store brand whose wall ovens were built for it by other appliance makers.
SourceSears PartsDirect: Kenmore 665 model wall oven error codes (archived)
Kenmore 665-prefix wall ovens with a meat probe.
Before you book,
in this order.
Each step comes from Kenmore's own guidance for F4/E1 on its ovens. Follow it to the end: the last card says whether this is a visit.
Unplug the probe and look for a bent tip, crushed cable or damaged plug.
Reset power at the breaker and cook without the probe.
If the code returns without the probe, book a visit to check the jack and wiring.
Still there?
It usually turns into temperature sensor and calibration. Book with the code and the model number.
What not to do
It is not the oven's own temperature sensor; ordinary baking does not use the probe.
What you may
notice with it.
The oven problems F4/E1 tends to arrive with. Answer these at the oven before anyone is booked.
All problems
Oven Error Code
6 causes, cheapest first
Where F4/E1 usually leads
Temperature sensor and calibration.
Kenmore
ovens.
A Sears store brand whose wall ovens were built for it by other appliance makers.
Kenmore oven repairMore Kenmore codes
Temperature sensor on other makes
In Kenmore's own words
Meat probe malfunction - shorted
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Kenmore 665-prefix wall ovens with a meat probe.
Kenmore F4/E1 oven repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F4/E1.
Can I clear F4/E1 myself?
Can I keep baking without the probe if my Kenmore shows F4/E1?
Is a new probe enough to fix Kenmore F4/E1?
Back to your everyday
Still showing F4/E1?
Book with the code exactly as shown, the full model number, and whether you can smell gas or burning — with a code, that is where the diagnosis starts.